Instruction Booklet5-Series
18
TROUBLESHOOTING
Flash Code/Fault
Impact
on Scooter
Notes
1. Battery needs
recharging
Will drive
Battery charge is running Iow.
Recharge the batteries as soon as possible.
6. Out of neutral at
power-up
Drive
inhibited
Throttle is not in neutral position when turning
key switch on. Return throttle to neutral, turn
power off, and back on again. Throttle may
n
eed to be re-calibrated (see Section 4.2.3).
C
heck throttle wiring.
7. Speed Pot error
Drive
inhibited
The throttle or its wiring is faulty. Check for
o
pen or short circuits. Throttle may not be
correctly set up. Contact your service agent.
8. Motor volts error
Drive
inhibited
The motor or its wiring is faulty. Check for
open or shot circuits. Contact your service
a
gent.
9. Other internal
errors
Drive
inhibited
Contact your service agent.
Drive
inhibited
Battery charge is empty. Recharge the batteries.
I
f the scooter is left off for a few minutes, battery
c
harge might recover enough to allow driving
f
or a short time.
2. Battery voltage
too Iow
Drive
inhibited
The scooter has drawn too much current for
too long, possibly because the motor has been
over-worked, jammed or stalled. Turn the scooter
power off, leave for a few minutes, and then
t
urn the power back on again. The controller
has detected a shorted motor. Check the loom
f
or shorts and check the motor. Contact your
service agent.
4. Current limit
time-out
Drive
inhibited
Battery charge is too high. If a charger is
p
lugged in, unplug it or turn the Charge/Run
s
witch to Run. Scooters powered by RHINO
c
harge the batteries when travelling down
s
lopes or decelerating. Excessive charging
i
n this manner can cause this fault. Turn the
s
cooter power off then on again. If necessary,
reduce speed when descending the slope.
3. Battery voltage
too high
Drive
inhibited
Check that the park-brake release lever is in
t
he engaged position. Check that the motor/
park-brake connector is plugged in firmly. The
park-brake coil or wiring is fauly. Check the
park brake and wiring for open or short circuits
If necessary, unplug the motor/park-brake
connector and check that all four pins are in the
correct position. If this flash code does not
a
ppear until the throttle has been moved out of
n
eutral, check for a short in the park-brake
circuit. If this flash code appears at power-up,
c
heck for an open circuit in the park-brake
c
ircuit. Contact your service agent.
5. Brake fault
To check the Self-Diagnostic Warning Light, turn on the key and count the number of flashes.
To Next Page
Loading...
Need help?
General
