SW1
SW1
TECHNICAL DATA
Contol unit supply 230 Vac
Fuse 2,5 A
Operating temperature -10°C / +60°C
Time of work 2 minutes
Output supply 1 motor 230 Vac
Power maximum motor 300W
Protection level IP56
Radio receiver 433,92 MHz integrated
7) SW1 ADJUSTMENT
The SW1 jack adjusts the possible re-opening of the sun shade curtain after a wind alarm:
SW1 jack open:
when the wind alarm stops, the curtain moves again to the original position.
If the sun shade curtain was open, it will open again.
SW1 jack closed:
when closed, the curtain remains closed when a wind alarm triggers.
To re-open it, an opening control signal must be sent.
8) INSTALLATION RESET
At first installation, after checking the good operation of the
wind alarm, when the wind speed is reached the sun shade
curtain must close. To avoid waiting for 8 minutes, power the
control unit on and off.
9) HOW TO PROGRAMME THE TRANSMITTER (14 tran-
smitters max)
To programme the transmitter, press and release the SP2
key: the L2 LED switches on and the buzzer makes a con-
tinuous sound. Press key 1 of the transmitter for around 4
seconds from the buzzer switching off. Release the transmit-
ter key and press it again for 2 seconds: the L2 LED flashes
three times and the buzzer makes an intermittent sound. The transmitter code is now stored in the memory
card.
If the intermittent sound is not heard for 15 seconds, repeat the above-mentioned steps.
10) HOW TO ERASE THE CENTRAL MEMORY
To erase all transmitter codes from the control unit memory, press the SP2 key and keep it pressed for 10-
15 seconds, until the red L2 LED starts flashing.
11) DISPLAY OF THE LEDs (L1, L2)
Red L2 LED flashes a wind alarm has triggered. The control unit sends a closing control signal to
all motors; they can start again for re-opening after 10 minutes.
To Next Page
Loading...
