12
7.4
- Press the button to f ire a
t e st a s h.
Caution:
1. W h e n th e a s h is sw it c h e d ON b ut
not used, after a certain period
of ti m e, t h e a s h’s p o w e r t u r n s
off automatically. However, the
a s h stil l co n s u m e s p o w er a n d
batteries discharge over a long
period of time, which may damage
t h e b att e r y c o nt a ct s of t h e a s h.
Therefore, s h ut of f th e a s h
p o w e r if th e a s h is n ot i n u s e.
2. The overheating protection of the
R F 60X m a y st o p t h e a s h f r o m
f iring after a number of full
power ashes have been f ired in
short intervals. The temperature
warning signal will appear in
the status bar of the LCD
display. If this occur, allow a
rest time of about 15 minutes
a n d t h e a s h w i l l t h e n r etu r n t o
nor mal.
3. T o pr ev e nt t h e a s h f r o m o v e r -
heating, turn on the Cooling Mode
(see Section 12.1).
Adjusting the Flash Head
B y p oi nti n g th e a s h t o w a r d a w a l l o r
ceiling, the ash will bounce off
the surface before illuminating the
subject. This will soften the shadows
behind the subject for a more
To Next Page
Loading...