Cactus V6 - Copying Custom Flash Profiles

33
Once you have f inished learning a number of
ash prof iles with one V6, you may copy all
the custom ash prof iles to other V6 units.
1. Set all the V6 units to the same channel.
2. Pick out the V6 source unit containing
all the learned ash prof iles that you
wish to copy to other V6 units. Switch
it on in TX mode. Press , and turn the
selection dial until the LCD shows <COPY
FLASH SETUP>. Press , and turn the
selection dial to <START>. Press
again. The LCD screen will then show
<S E T R X T O C O P Y P R OF I L E > w it h a n o ptio n
<G O >.
3. Switch on the V6 destination unit(s) in
RX mode. Press , and turn the
s el e c tio n d i a l t o < F L A S H S E T U P >. P r e s s
a n d t u r n t h e d i a l t o < C OP Y PR O F I L E >.
Press . The LCD screen will show
<WAITING FOR TX>.
4. On the V6 source unit, press to
conf irm <GO>.
5. The V6 units will start copying the ash
prof iles.
6. When the ash prof iles are all copied
to the V6 destination units, the source
V6 u n it w i ll s h o w <F I N I S H E D S E N DI N G >
10.3
Copying
Custom
Flash
Profiles