37
12. Remote Manual Power
Control
Apart from ash triggering, the V6 can also
command the manual power of your ash. On
each RX, choose the appropriate ash prof ile
fo r e a c h a s h t o b e c o n n e c t e d. T h e V 6 T X
w i ll t h e n b e a ble t o c o m m a n d t h e a s h t o
f ire from 1/128 to 1/1 full power. V6 offers
two power def initions for users to command
the ashes’ power in the most convenient
w a y.
To remotely control the power of your ash
u nits:
1. Connect the ash units to the V6.
2. Switch on the ash units in TTL mode.
Then switch on the V6 in RX mode.
3. C h o o s e t h e c o r r e ct a s h p r o l e for each
V6.
Similar to a common ash display, the V6 TX
indicates the power level of the remote
ashes in proportion to full power in
relative power mode, i.e., 1/1 for full
power, 1/2 for half power, etc. Upon
switching on the V6 in TX mode, the LCD will
12.1
Relative
Power
To Next Page
Loading...
