Cactus V6 - Page 70

70
LED BLINKS? POSSIBLE CAUSE SOLUTION
TX: Yes
(Gr e e n)
RX: No
1. Poor battery
contact or
battery out of
power on RX
Replace the
batteries in the
RX and retry
2. Channel and
group mismatch
Ensure both
transceivers are
set to the same
channel and the
group assigned to
the RX has been
activated on the TX
3. Back g rou nd
radio
interference
- Set both
transceivers to
another channel
- Change setup
location as
interfere nce ma y
come from other
equipment in
the surrounding
area
4. Beyond 100m
effective
range
Make sure TX and
RX transceivers
are placed within
10 0 m (3 2 8 f t) of
each other
5. TX and RX
transceivers
are placed too
close to each
other
Choose <SHORT> in
the working range
sub-menu