CADD Prizm - User Manual

To Next Page

7-01-014 CADD PRIZM POWER PACK INSTRUCTION FOR USAGE

REVISED: 11/2016

CADD PRIZM POWER PACK INSTRUCTION FOR USAGE

Charging the Power Pack

Before each use, recharge the power pack as described below.

Within the charging temperature range [50F to 95F], the power pack will become fully charged in

approximately 7 hours or less.

NOTE: Use the Battery Refresh Cycle to discharge and recharge the power pack automatically

 Before first use

 Every 30 days while in regular use

 At least once every 6 months while in storage

TO CHARGE THE POWER PACK:

1. Attach the AC adapter connector to the power pack INPUT connector

NOTE: The power pack may remain attached to the pump during charging. Running the pump

while charging the power pack will not drain power from the power pack.

2. Plug the AC adapter’s 3-prong plug into an AC wall outlet.

CAUTION: Do not remove the grounding prong of the AC adapter or use a 2-prong adapter with

the AC adapter.

Need help?

Do you have a question about the CADD Prizm and is the answer not in the manual?

Summary

Step-by-step instructions for connecting the power pack to an AC outlet for charging.

Instructions for connecting the power pack output connector to the CADD-Prizm pump.

Procedure for using the Battery Refresh Cycle to restore or maintain battery capacity.

Identifies common problems, their probable causes, and recommended solutions for the EPS system.

General

Manufacturer	Smiths Medical
Volume Range	0.1 to 9999 mL
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Device Type	Infusion Pump
Model	CADD Prizm
Infusion Modes	Continuous, Intermittent, PCA
Power Source	Battery
Display	LCD
Programming	Keypad
Reservoir Capacity	CADD Medication Cassettes
Alarms	Occlusion, Air-in-line, Low battery, System error
Compatibility	CADD Medication Cassettes
Altitude Range	Up to 10, 000 feet (3, 048 meters)