II. USING THE HANDSET
Additional Handset Commands
Note: All codes must be done from (SB) mode. The CaddyTrek
powers up in (SB) mode and returns to (SB) mode upon exiting
any other mode.
1. Mute the handset:
a. Press the DOWN arrow (4) times then press STOP
b. Repeat steps to disengage
2. Check the handset battery charge level:
a. Turn on the handset
b. Press and hold the STOP button for 2-3 seconds
c. Read LED light indicators left to right
i. 4 green lights = 100% charged
ii. 3 green lights = 70% charged
iii. 2 green lights = 40% charged
iv. 1 green light = 10% charged
3. Recalibrate CaddyTrek
If the unit veers to the left or to the right, you may need to
recalibrate.
a. Turn unit on.
b. Press LEFT, RIGHT, LEFT, RIGHT, then press STOP.
c. The unit will beep twice.
4. Engage free wheel mode
a. Hold down the UP directional button until you hear a beep.
b. Press STOP to lock the wheels.
Using the Directional Buttons
Press the Forward, Reverse, Left or Right directional buttons
to move CaddyTrek in the desired direction.
To accelerate CaddyTrek to its maximum speed, hold down
the Forward button or press repeatedly.
To slow CaddyTrek down to a stop while moving forward,
repeatedly press the Reverse or Stop button. Once stopped,
pressing once more will reverse the unit.
To go back into Standby (SB) mode, press STOP, STOP.
Pg. 6
To Next Page
Loading...