Need help?Do you have a question about the Cadence CEQ735 and is the answer not in the manual?
Connects the power supply wires (Ground, Remote, Power) to the unit.
RCA cables connect to the front channel amplifier.
RCA cables connect to the rear channel amplifier.
RCA cables connect from the main source unit.
RCA cables connect from the auxiliary source unit.
RCA cables connect to the subwoofer amplifier.
Adjusts gain for left and right auxiliary inputs.
Selects low pass frequency between 60Hz and 90Hz.
Independent level control for subwoofer output.
Master control for the overall output level.
Adjusts output balance between front and rear speakers.
Selects between auxiliary and main audio inputs.
Seven band controls for adjusting frequency response (boost/cut).
Temporarily disconnects amplifier power to avoid damage during setup.
Sets amplifier input sensitivity to the lowest level before calibration.
Sets the equalizer's master volume to its highest setting.
Sets the head unit volume to maximum and then slightly reduces it.
Calibrates input levels for main/aux sources using unit's controls.
Lowers equalizer volume and re-enables amplifier power.
Powers up the system and gradually increases volume to desired listening level.
Adjusts amplifier gains if desired listening level is not achieved.
Choosing a suitable place to mount the unit under the dashboard.
Drilling pilot holes for the mounting bracket using specified drill bit size.
Securing the CEQ735 unit to the previously installed mounting bracket.
General| Brand | Cadence |
|---|---|
| Model | CEQ735 |
| Category | Stereo Equalizer |
| Language | English |
To Next Page