Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane-Change Signals. See Turn and
Lane-Change Signals on page 3-8
• 3 Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on page 3-9
• Flash-To-Pass Feature
• N Windshield Wipers. See Windshield Wipers on
page 3-13.
• L Windshield Washer. See Windshield Washer
on page 3-15.
• _ Heated Washer Fluid. See Windshield Washer
on page 3-15.
Turn and Lane-Change Signals
To signal a turn, move the lever all the way up or down.
The lever returns automatically when the turn is
complete. If you momentarily press and release the
lever, the turn signal will flash 3 times.
An arrow on the instrument
panel cluster and in the
outside rearview mirror will
flash in the direction of
the turn or lane change.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change is
complete. The lever returns when it is released.
If the turn signal is left on, a warning chime will sound
and the Driver Information Center (DIC) will display
TURN SIGNAL ON after driving about a mile to remind
you to turn it off.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned out signal bulb.
Other drivers will not see the turn signal.
Replace burned-out bulbs to help avoid possible
accidents. Check the fuse and for burned-out bulbs if
the arrow fails to work when signaling a turn. See Rear
Underseat Fuse Block on page 5-96.
3-8
To Next Page
Loading...
Need help?
General
