The cruise control
buttons are located
on left side of the
steering wheel.
I(On): This position turns on the system.
+ RES (Resume/Accelerate): Press this button
to make the vehicle accelerate or resume to a
previously set speed.
SET– (Set): Press this button to set the speed.
[ (Cancel): Press this button to cancel cruise control.
Cruise control will not work if the parking brake is
set, or if the master cylinder brake fluid level is low.
If the brakes are applied, the cruise control shuts off.
The cruise light on the instrument panel cluster comes on
after the cruise control has been set to the desired speed.
1. Press the cruise control button.
2. Get up to the desired speed.
3. Press the SET– button located on the steering
wheel and release it.
4. Take your foot off the accelerator.
Resuming a Set Speed
Suppose you set the cruise control at a desired speed
and then you apply the brake. This shuts off the
cruise control. But you do not need to reset it.
Once the vehicle is traveling approximately 25 mph
(40 km/h) or more, you can press the +RES (resume/
accelerate) button to return to your desired preset speed.
The cruise light displays again.
The vehicle returns to and stays at your preset speed.
If you press and hold the +RES button, the vehicle
speed increases until you release the button or apply
the brake. Do not hold in the +RES button, if you do
not want the vehicle speed to increase.
3-17
To Next Page
Loading...
Need help?
General
