Phone Commands
These commands only function if a Bluetooth
®
phone
has been paired with the navigation system, is available
in the vehicle, and is on.
Phone enter: Instructs the system to dial a phone
number after it is stated. State the number including the
area code (ex. 555 123 4567) then state “dial.” The phone
number can be stated in partial segments or the entire
phone number can be stated. If the number is stated in
partial segments the system plays back each segment.
Correction: Deletes the last segment of the phone
number that was spoken.
Delete: Deletes the entire phone number.
Dial: Dials the phone number.
Phone dial name: Instructs the system to dial the
phone number of a specific previously stored name.
The system responds with “Name Please”. State the
stored name. The system plays back the name and
requests a confirmation. Respond with a yes or no.
The system dials the number. See “Phone Book
Screen” under “Dialing and Making Calls Using Your
Bluetooth
®
Phone” under Bluetooth
®
Phone on page 6-2
for more information on how to store a nametag.
Phone redial/recall: Instructs the system to redial a
phone number.
Phone help: Instructs the system to assist with phone
commands. Help commands display on the map
screen when the vehicle is stopped.
The word “telephone” can be substituted in place of the
word “phone”.
OnStar
®
Command
OnStar: Instructs the system to connect to OnStar
®
and the OnStar
®
voice recognition system. Refer to the
OnStar
®
manual for more information.
4-14
To Next Page
Loading...
