In Brief 1-5
Keyless Access
Press
K to unlock the driver door.
Press again within five seconds to
unlock all remaining doors.
Press
Q to lock all doors.
Lock and unlock feedback can be
personalized. See Vehicle
Personalization on page 5‑46.
Press and hold
V / 8 to open
the trunk/liftgate.
Press
L and release to locate the
vehicle.
Press and hold
L for more than
two seconds to sound the panic
alarm.
Press
L again to cancel the panic
alarm.
For keyless access vehicles, press
the button (A) to remove the key.
The key can be used for all locks.
See Keys on page 2‑2 and Remote
Keyless Entry (RKE) System
Operation (Key Access) on
page 2‑5 or Remote Keyless Entry
(RKE) System Operation (Keyless
Access) on page 2‑6.
Remote Vehicle Start
For vehicles with this feature, the
engine can be started from outside
of the vehicle.
Starting the Vehicle
1. Aim the Remote Keyless Entry
(RKE) transmitter at the vehicle.
2. Press and release
Q.
3. Immediately after completing
Step 2, press and hold
/ for at
least four seconds or until the
vehicle's turn signal lamps flash.
When the vehicle starts, the parking
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system may come on.
The engine will continue to run for
10 minutes. Repeat the steps for a
10-minute time extension. Remote
start can be extended only once.
Canceling a Remote Start
To cancel a remote start:
.
Aim the RKE transmitter at the
vehicle and press and hold
/
until the parking lamps turn off.
.
Turn on the hazard warning
flashers.
.
Turn the vehicle on and then off.
See Remote Vehicle Start on
page 2‑12.
To Next Page
Loading...
Need help?
General
