1-10 In Brief
column position, if the vehicle is
equipped with the power tilt and
telescopic steering column.
1: Saves and recalls for driver 1.
2: Saves and recalls for driver 2.
B : Moves the driver seat and/or
power steering column to the exit
position. See “Exit Recall” later in
this section for more information.
Storing Memory Positions
To save into memory:
1. Adjust the driver seat, outside
mirrors, and the power steering
column, if equipped, to the
desired driving positions.
2. Press and hold “1” until two
beeps sound.
3. Repeat for a second driver
using “2.”
To recall memory positions, press
and release “1” or “2.” The vehicle
must be in P (Park) for an automatic
transmission, or the parking brake
must be applied for a manual
transmission. A single beep will
sound when the button is pressed.
The seat, outside mirrors, and/or
power steering column will move to
the position previously stored for the
identified driver.
If entry/exit recall is programmed on
in the vehicle personalization menu,
automatic entry recall occurs when
the ignition is turned on.
See Memory Seats on page 3‑8 and
Vehicle Personalization on
page 5‑46 for more information.
Exit Recall
B : Press to move the driver seat
back a preset distance and/or the
power steering column, if equipped,
up and forward. A single beep
sounds when the exit feature
activates. The vehicle must be
in P (Park) for an automatic
transmission, or the parking brake
must be applied for a manual
transmission.
If entry/exit recall is programmed on
in the vehicle personalization menu,
automatic seat and/or steering
column movement occurs under
certain conditions. See Memory
Seats on page 3‑8 for more
information.
Heated and Ventilated
Seats
Heated and Ventilated Seat
Buttons Shown, Heated Seat
Buttons Similar
If available, the buttons are on the
climate control panel. To operate,
the ignition must be on.
M : Press to heat the seat.
To Next Page
Loading...
