Cadillac CTS/CTS-V Owner Manual (GMNA-Localizing-Europe-11374014) -
2018 - crc - 9/14/17
VEHICLE CARE 301
21. Dispose of the used sealant
canister (5) and sealant/air hose
(6) assembly at a local dealer or
in accordance with local
regulations and practices.
22. Replace with a new canister
assembly available from your
dealer.
23. After temporarily sealing the tyre
using the tyre sealant and
compressor kit, take the vehicle
to an authorised dealer within
161 km (100 mi) of driving to
have the tyre repaired or
replaced.
Using the Tyre Sealant and
Compressor Kit without Sealant
to Inflate a Tyre (Not Punctured)
To use the air compressor to inflate a
tyre with air only and not sealant:
If a tyre goes flat, avoid further tyre
and wheel damage by driving slowly
to a level place. Turn on the hazard
warning flashers. See Hazard Warning
Flashers 0 153.
See If a Tyre Goes Flat 0 295 for other
important safety warnings.
1. Remove the tyre sealant and
compressor kit from its storage
location. See Storing the Tyre
Sealant and Compressor Kit 0 303.
2. Unwrap the air only hose (7) and
the power plug (8).
3. Place the kit on the ground.
Make sure the tyre valve stem is
positioned close to the ground so
the hose will reach it.
4. Remove the tyre valve stem cap
from the flat tyre by turning it
anticlockwise.
5. Attach the air only hose (7) onto
the tyre valve stem by turning it
clockwise until it is tight.
6. Plug the power plug (8) into the
accessory power outlet in the
vehicle. Unplug all items from
other accessory power outlets.
See Power Sockets 0 114.
If the vehicle has an accessory
power outlet, do not use the
cigarette lighter.
To Next Page
Loading...
