Cadillac SRX 2016 - Turn Signal Lamps

Cadillac SRX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
9087647) - 2016 - crc - 5/4/15
266 Vehicle Care
Daytime Running Lamp (DRL)
(Uplevel)
1. From the back side of the
headlamp assembly, remove
the bottom cap to replace the
DRL bulb.
2. Disconnect the electrical
connector.
3. Remove the DRL bulb socket
from the headlamp assembly.
4. Replace the bulb in the bulb
socket.
5. Install the bulb socket in the
headlamp assembly.
6. Connect the electrical
connector.
7. Install the cap with the down
arrow pointing down in the
back of the headlamp
assembly.
8. For the driver side, reinstall the
underhood electrical center
cover by latching the three
clips.
9. For the passenger side,
reinstall the air filter/cleaner
assembly base by pushing to
seat. Verify the base is seated
securely, then install the engine
air filter/cleaner assembly.
Front Turn Signal Lamp (Base
and Uplevel)
To replace the front turn
signal lamp:
1. Remove the turn signal lamp
bulb socket from the headlamp
assembly.
2. Remove the turn signal lamp
bulb from the socket.
3. Replace the bulb in the bulb
socket.
4. Install the bulb socket in the
headlamp assembly.
5. For the driver side, reinstall the
underhood electrical center
cover by latching the three
clips.
6. For the passenger side,
reinstall the air filter/cleaner
assembly base by pushing to
seat. Verify the base is seated
securely, then install the engine
air filter/cleaner assembly.
Turn Signal Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
0 37.