19
ELECTRIC PARKING BRAKE
TIRE PRESSURE MONITOR
AUTOMATED CAR WASH MODE
To apply the parking
brake, press the
Parking Brake
switch on the left side
of the instrument panel.
To release the parking
brake, turn on the
ignition, press the
brake pedal, and then
press the
switch.
See Driving and Operating in your Owner Manual.
The
Low Tire Pressure warning light on the instrument cluster
illuminates when one or more of the vehicle’s tires is signicantly
underinated. Fill the tires to the proper tire pressures listed on
the Tire and Loading Information label, located below the driver’s
door latch. Current tire pressures can be viewed on the Driver
Information Center.
See Vehicle Care in your Owner Manual.
To place the transmission in Neutral with the engine running for an
extended period of time:
1. While pressing the brake pedal, open the driver's door and
then shift to N (Neutral). If the door is opened after shifting to
Neutral, the transmission may shift to Park.
2. The indicator should show N. If it does not, select Neutral again.
3. Upon returning to the vehicle, shift into Park.
See Driving and Operating in your Owner Manual.
The rear camera mirror provides a wide angle camera view of the
area behind the vehicle.
Pull or push the lever (A) at bottom of mirror to turn the video
display on or off.
To adjust the brightness of the display, press and release the
button (B) on the top back of the mirror without covering the
light sensor. There are 5 brightness settings.
See Keys, Doors and Windows in your Owner Manual.
REAR CAMERA MIRROR♦
♦ Optional equipment
B
A
To Next Page
Loading...
