Cake Kalk& - Charging Steps and Post-Charge Care

Charging Steps
• Disconnect the kill switch, turning the bike o.
• Connect the charger to the battery (accessible by removing the seat or
on the right motor fender). Remove the protective plug on the charger
connector by pressing the silver button and pulling the plug.
• Plug the charger into an outlet, ensuring voltage compatibility.
• A green light indicates completed charging.
• Unplug the charger from the outlet before disconnecting it from the
battery. Replace the protective plug.
Post-Charging
Never ride within 30 minutes after charging to let the battery cool down
before use.
Safety Precautions
Never charge unsupervised. Always be attendant during the entire charging
process. Only use the original CAKE charger with the CAKE Kalk bike. Do not
activate the kill switch on the handlebar during charging to avoid accidental
activation.
2.6 Side-view mirrors
1. Loosen the two screws a couple of turns.
2. Adjust the mirror to the preered height.
3. Tighten the two screws.
1. 3.
2.