Cake Kalk& - Suspension; Drivetrain and Chain

A
Adjusting the handlebar angle
See the instruction video on ridecake.com/en/makka-manuals-and-videos/ .
Tool: Allen key 5 mm.
1. Loosen the 4 stem bolts.
2. Adjust the handlebar angle and center the handlebar. Make use of the
handlebar guidelines.
3. Tighten the 4 stem bolts to 10 Nm.
4. Ensure to tighten the upper and lower bolts equally. Check that the gap
(A) between the upper and lower stem is equal. See Fig 1.
3.5 Suspension
Read the Öhlins manual at www.ridecake.com/manuals to change the
factory settings for your bodyweight and riding style. If the bike is not used
for longer periods of time, the fork might start leaking oil. This is due to the
rubber gaskets drying up. It’s therefore recommended not to let your bike
stand idle for too long periods at a time. Make sure that the linkage has no
damage. Make sure that all bolts on the linkage is firmly tightened.
3.6 Drivetrain and Chain
Chain
Check that the chain is in good condition. It’s advised to clean your chain and
applying chain lubricant when needed in order to prolong the lifetime of your
chain. Check that the chain has correct tension. The chain gets longer as the
bike is being used and will needed to be tensioned with time. It should have