How to fix cloudy water in my Cal Spas Hot Tub?
Cloudy water in your Cal Spas Hot Tub can be due to a few reasons. It could be caused by a dirty filter, so cleaning the filter is recommended. You might also need to shock the spa with sanitizer, add sanitizer, adjust the pH and/or alkalinity to the recommended range, run the jet pump while cleaning the filter, or, as a last resort, drain and refill the spa.
What to do if my Cal Spas F-168 has a water odor?
If your Cal Spas Hot Tub has a water odor, it could be due to excessive organics in the water or improper sanitation. To resolve this, shock the spa with sanitizer or add sanitizer. If the pH is low, adjust it to the recommended range.
How to get rid of algae growth in my Cal Spas F-168?
Algae growth in your Cal Spas Hot Tub is often due to high pH or low sanitizer levels. If the problem is visible or persistent, shock the spa with sanitizer. If necessary, drain, clean, and refill the spa.
How to remove stains from my Cal Spas Hot Tub?
Stains in your Cal Spas Hot Tub can be caused by total alkalinity and/or pH being too low, or high iron or copper in the source water. Adjust the total alkalinity and/or pH. You can also use a stain and scale inhibitor.
How to clean organic buildup/scum ring around my Cal Spas Hot Tub?
Organic buildup or a scum ring around your Cal Spas Hot Tub is caused by a buildup of oils and dirt. Wipe off the scum with a clean rag. If the buildup is severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and then refill the spa.
Why does my Cal Spas F-168 have eye irritation?
Eye irritation in your Cal Spas Hot Tub can occur if the pH or sanitizer level is too low. Adjust the pH to the correct level. You may also need to shock the spa with sanitizer and maintain the proper sanitizer level.
What causes skin irritation/rash in my Cal Spas F-168 Hot Tub and how to solve it?
Skin irritation or rash in your Cal Spas Hot Tub can be caused by unsanitary water or a free chlorine level above 5ppm. Shock the spa with sanitizer and maintain the sanitizer level. Also, allow the free chlorine level to drop below 5 ppm before using the spa.
How to eliminate musty odor from my Cal Spas F-168?
A musty odor in your Cal Spas Hot Tub is typically caused by bacteria or algae growth. To fix this, shock the spa with sanitizer.
What causes scale buildup in my Cal Spas F-168 and how to remove it?
Scale buildup in your Cal Spas Hot Tub is often due to high calcium content in the water, or total alkalinity and pH being too high. To address this, adjust total alkalinity and pH. If scale removal is required, drain the spa, scrub off the scale, refill the spa, and balance the water.
General| Seating Capacity | 6-7 |
|---|---|
| Heater | 5.5 kW |
| Shell Material | Acrylic |
| Frame Material | Pressure-treated wood |
| Control System | Balboa |
| Voltage | 240V |
| Amperage | 50A |
| Lighting | LED multi-color lighting |
| Insulation | Full foam |
| Filtration | 2 - 50 sq ft Filters |
To Next Page