This feature is used to designate the strength of the signals at which the radio will stop
during automatic tuning. "Distance" is the default, allowing the radio to stop at a broader
range of signals. To set the unit to select only strong local stations during automatic tuning,
rotate the volume control until "Local" appears in the display.
AREA (TUNER FREQUENCY SPACING)
This option allows the selection of the frequency spacing appropriate for your area. "AREA
EURO” is the default setting. Rotate the volume control to select the U.S.A. Latin America,
Europe or Oirt options.
LOCAL/DISTANCE SELECT
REGIONAL ON/OFF ( REG )
REGIONAL “OFF” will be displayed by default. The user now has 5 seconds to adjust by
using volume up/down button from “off” to “On” . If “on” is selected when the AF search
or PI seek, it will implement to station which have all the PI codes which are the same as
current station.. If “off” is selected, when AF search or PI seek the regional code in the
format PI code will be ignored. AF regional station is possible to be received.
The Regional function On/Off Setting is valid when the “AF” function is “on”
The beep tone feature allows the selection of an audible beep tone to be heard each time a
button is pressed on the face of the radio. "BEEP TONE On" is the default display. Rotate
the volume control to select the "BEEP TONE Off" option.
BEEP TONE (BEEP)
E - 10
Turn the encoder volume to select the TA function ON/OFF.
TA ON / OFF
To Next Page
Loading...
