California Air Tools 10020C-22060 User Manual

California Air Tools 10020C-22060

17 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

ULTRA QUIET & OIL FREE

AIR COMPRESSOR

OwnER'S MAnUAL

CALIFORnIA AIR TOOLS

10020C-22060

2.0 HP

6.40 CFM @ 40 PSI

5.30 CFM @ 90 PSI

220 vOLTS 60 HERTz

10.0 gALLOn STEEL TAnk

)))"$!$&""%" A?@;91>%A<<;>@

Questions and Answers:

A
Anthony HobbsJul 27, 2025
Why won't my California Air Tools 10020C-22060 Air Compressor motor start?
- C
  Christy MitchellJul 27, 2025
  If your California Air Tools Air Compressor motor doesn't start or starts slowly, it might be due to low voltage supply. Check that the main voltage matches the air compressor's specifications. Using an extension cord that's too thin or long can cause a voltage drop. Use heavy-duty extension cords and ensure the compressor is plugged into a fully functional power outlet.
M
mbarberAug 1, 2025
What to do if the unloader valve leaks on my California Air Tools Air Compressor?
- D
  Dr. Peter Gardner PhDAug 1, 2025
  If the unloader valve on your California Air Tools Air Compressor leaks when it's idle, the unloader valve seal might be defective. Release all the pressure from the air tank, then remove the unloader valve plug and clean the valve seal. If necessary, replace the seal and reinstall all components.
G
ginarossAug 8, 2025
How to fix a pressure drop in my California Air Tools Air Compressor tank?
- A
  Anita ReynoldsAug 8, 2025
  If you notice a pressure drop in the tank of your California Air Tools Air Compressor, it could be due to air leaks at the connections. Let the compressor build pressure, ideally to the maximum. Apply soapy water to the air connections and watch for bubbles. Tighten any connections that are leaking. If the problem continues, further assistance may be needed.
M
Miranda JohnsonAug 14, 2025
What to do if my California Air Tools 10020C-22060 Air Compressor stopped and does not start?
- J
  John WagnerAug 14, 2025
  If your California Air Tools Air Compressor stops and won't restart, the thermal protector may have activated due to the motor overheating. Ensure the main voltage matches the compressor's specifications. A thin or long extension cord can cause a voltage drop and overheating. Also, excessive use (over 1 hour continuously) can overheat the motor. Allow the motor to cool down.
J
Juan CampbellAug 20, 2025
Why is my California Air Tools 10020C-22060 not providing enough air?
- A
  Arthur RobinsonAug 20, 2025
  If your California Air Tools Air Compressor doesn't seem to provide as much air as before, or cuts off sooner, it could be due to a tank full of water from condensation. Open the drain valve and release the water from the tank.

California Air Tools 10020C-22060 Specifications

General

Brand	California Air Tools
Model	10020C-22060
Category	Air Compressor
Language	English

Summary

Important Safety Instructions

Risk of Cutting

Details hazards associated with moving parts and precautions to prevent severe trauma.

Risk of Electric Shock

Highlights risks of electric shock, emphasizing use of undamaged cords and proper grounding.

Locations of Important Labels

Pre-Operation Checklist and Setup

Electrical Power and Operation

Electrical Power Requirements

Details voltage, amperage, and grounding requirements for safe operation.

Electrical Extension Cords

Provides guidelines for selecting and using appropriate extension cords.

Operating the Air Compressor

Introduction to operating the air compressor, including assembly steps.

Test Run and Daily Operation

Test Run Procedures

Step-by-step guide for performing an initial test run of the air compressor.

Daily Operation

Maintenance and Storage

Draining the Air Tank

Troubleshooting

Limited Warranty Information

Warranty Coverage and Periods

Details the terms, conditions, and duration of the limited warranty for the air compressor.

Disclaimers and Limitations

Related product manuals

Preview: California Air Tools 10020C

California Air Tools 10020C

Preview: California Air Tools 10020CHAD

California Air Tools 10020CHAD

California Air Tools 10020

Preview: California Air Tools 10020AC

California Air Tools 10020AC

Preview: California Air Tools 10020DCAD

California Air Tools 10020DCAD

Preview: California Air Tools 10020DSPC

California Air Tools 10020DSPC

Preview: California Air Tools 1610A

California Air Tools 1610A

Preview: California Air Tools 15020C

California Air Tools 15020C

Preview: California Air Tools 1P1060SP

California Air Tools 1P1060SP

Preview: 15020C-22060

Preview: California Air Tools 8010

California Air Tools 8010

Preview: California Air Tools 4610ALFC

California Air Tools 4610ALFC