EasyManua.ls Logo

California Instruments 801P Series - User Manual

Default Icon
95 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Revision H
May 2000
Copyright 1996,1997,1998,1999,2000
By California Instruments.
All rights reserved.
P/N 5002-966
801P / 1001P / 1251P Series
AC Power Source
User and Programming Manual

Table of Contents

Questions and Answers

  • K
    kenneth23Aug 9, 2025
    What to do if no output LEDs are lit on California Instruments AC Power Distribution?
    • L
      Lauren ThompsonAug 9, 2025
      If none of the output LEDs on the front panel of your California Instruments AC Power Distribution unit are lit, the issue lies within the DC-AC board. If all LEDs light up after powering on, replace the DC-AC module because it likely has a shorted gate drive and blown power transistors. If the LEDs stay off, replace the DC-DC board. If the fuse is blown with signs of damage on the board, do not replace the fuse; replace the DC-AC module. However, if there's no visible damage, replacing the fuse and trying again is acceptable.
  • C
    corey11Aug 23, 2025
    How to troubleshoot no output and no front panel LEDs on California Instruments 801P AC Power Distribution?
    • B
      Barbara NelsonAug 23, 2025
      If there is no output and no front panel LEDs are illuminated on your California Instruments AC Power Distribution, check the following: if the LED is not lit but power is available at the EMI filter, replace the P.F.C. module. If the LEDs on the DC-DC board are lit but the front panel LEDs are not, the large ribbon cable between the DC-DC and AC converter is likely the problem. If fuses are blown and there are burn marks on components, do not replace the fuses; replace the DC-DC module.

California Instruments 801P Series Specifications

General IconGeneral
PhaseSingle-Phase
Storage Temperature-20°C to 70°C
Output Frequency45-65 Hz, 400 Hz
WaveformSine Wave
Harmonic Distortion<1% THD
Voltage Accuracy±0.1% of full scale
Current Accuracy±0.2% of F.S.
Frequency Accuracy±0.01%
ProtectionsOver Voltage, Over Current, Over Temperature, Short Circuit
Communication InterfaceRS-232
Operating Temperature0°C to 40°C
Input Power50/60 Hz

Related product manuals