Calix GigaSpire BLAST - Page 38

Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
38
After pairing, follow the Gateway Status
 After the pairing is complete (60 seconds after the signal
strength has been displayed), the light bar indication shall
follow the Gateway status as described on the Light Bar tab in
this spreadsheet.

 If the mesh is connected via Ethernet connection, if boot up
successfully, the light bar indication shall follow the Gateway
status as described on the Light Bar tab in this spreadsheet.
After 60 seconds, Cyan
or Red, or Off
Lost Control plane but data plane is still connected
Regardless of what stage the mesh unit is in. If the control plane
is loss but the data plane is still in connection. Then flash the LED
to red for 15 seconds, after that return the LED to cyan
Flash LED to red for 15
seconds, then revert to
Cyan