Calix GigaSpire BLAST - Wall Mount Template and Procedure

Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
39
Wall Mount Template
Inside the giftbox of the BLAST u4 or u4m, a printed wall mount template is included. This
template is scaled to size and should be used when marking the hole locations for the wall
mount option. The figure below is a representative example of the template but should not
be used as it is not scaled appropriately.
For additional information, refer to Wall Mounting the u4/u4m (on page 28) located in the
Installation chapter of this guide.
Example Wall Mount Drilling Template
Wall Mount Drilling Template, GigaSpire BLAST u4 & GigaSpire Mesh BLAST u4m
Note: Do not change scale of this template. Dimensions are 1:1
Drill Here
2.50”
6.35 cm
Drill Here
1.14”
2.9 cm
Interface Side
220-01181 Wall Mount Drill Template for BLAST u4 & BLAST u4m, R10