Calix GigaSpire BLAST - Powering and Connecting the GigaSpire BLAST

Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
33
Powering the BLAST u4/u4m
The information below describes the powering of any GigaSpire BLAST.
1. Locate the 12 VDC Power Adapter.
2. Attach one end (2-pin barrel connector) to the rear of the BLAST u4/u4m.
3. Plug the other end into any available 110/220 VAC wall outlet.
4. The GigaSpire BLAST begins its start-up sequence (Flashing blue LED).
GigaSpire BLAST u4/u4m Power Connection
To power up the BLAST u4 or u4m