8
REMOTE CONTROL LAYOUT (continued)
• To Sync the remote: if the cart does not respond using the remote:
1. Check to make sure the battery is connected properly & that the green power light is on. Also
make sure the remote is switched on and the red LED indicator light blinks when buttons
are pressed.
2. Power the remote on rst, then power the cart on so the green light indicator on the cart handle is on.
3. With the speed control knob turned fully counterclockwise (o position): rotate the speed control
knob roughly 20 degrees clockwise until there is a “click”. Do not rotate the knob any further
once you hear the “click”.
4. Next, press any button on the remote. The cart should respond from the remote input.
5. After the cart and remote have synced and the cart is now responsive from remote input, turn
the speed control knob fully counterclockwise (back to o position).
6. The cart should now automatically sync with the remote whenever the remote and cart are
powered on.
7. If the cart becomes unresponsive again from remote input, repeat the process of syncing the
remote and cart.
• The cart has three speeds in each direction:
1. UP - Forward (3 speeds by pressing: once, twice, 3 times)
2. DOWN - Reverse (3 speeds by pressing: once, twice, 3 times)
3. Arrow L - Left Turn (single clicks or holding)
4. Arrow R - Right Turn (single clicks or holding)
5. ‘Circle’ (middle button) - Stop
6. Play/Pause: this button runs the cart in the forward direction for distances:
• One Press: the cart runs for 20 yards
• Two Presses: the cart runs for 35 yards
• Three Presses: the cart runs for 50 yards
• Note: you can stop the cart by pressing the “circle” button at any time as well as steer
the cart using the arrow buttons.
To Next Page
Loading...