Cambridge Audio Alva TT v2 User Manual

14
Operating instructions
Last updated: June 28, 2022 03:06. Revision #4960
Playing Records:
Place your record over the spindle and onto the platter, then press the power button on the top panel.1.
Press required platter rotation speed button (33 or 45) on the top panel.2.
Raise the tonearm by moving the lift lever towards the rear of the turntable.3.
Position the tonearm over the desired location (groove) on the record.4.
Lower the tonearm slowly by moving the lift lever towards the front of the turntable.5.
Ending Play:
Lift the tonearm with the lift lever.1.
Move the tonearm back onto the tonearm rest.2.
Secure the tonearm with the tonearm clamp.3.
Press the platter speed button to stop the platter rotation.4.
Press the power button to enter standby.5.
Auto Power Down (APD).
The Alva TT V2 comes set up with Auto Power Down (APD) enabled and will automatically switch to standby mode after 20 minutes of inactivity.
To disable APD: Press and hold the power button for 5 seconds when in standby.
To re-enable APD: Hold down the power button when plugging the mains power cable into the turntable.
Note: APD is automatically disabled when Phono output is selected.

Cambridge Audio Alva TT v2 Specifications

General

Brand	Cambridge Audio
Model	Alva TT v2
Category	Turntable
Language	English