9
Installation instructions
Last updated: January 19, 2023 05:57. Revision #10623
Dependent on your desired setup, there are a few different ways to connect your Minx X201 subwoofer.
1. If you are using a two-channel hi-fi system, then use the left and right line input connections to connect your Minx X201.
2. If you are using a receiver, or amplifier with a dedicated sub out then connect the Minx X201 using the left channel (LFE/Sub) input.
3. Once connected you can decide where to position your subwoofer. As low frequency content is largely unidirectional, you can experiment to find
a place that suits your setup. Please see the below diagram for several suggestions on placement dependent on your speaker configuration.
To Next Page
