Standalone Keypad/Prox Access Control
8. To Reset to Factory Default
The unit uses a LDR (light dependent resistor) as an
anti-tamper alarm. If the keypad is removed from the cover,
the tamper alarm will operate.
a. Disconnect power from the unit
b. Press and hold # key while powering the unit back up
c. On hearing two “Beeps” release # key, system is now
back factory settings
9. Anti-Tamper Alarm
10. Sound and Light indication
11. Detailed Programming Guide
Operation Status Red Light Green Light Yellow Light Buzzer
Power on
-
Bright
-
Beep
Stand by Bright -
-
-
Press keypad - -
-
Beep
Operation successful - Bright
-
Beep
Operation failed - -
-
Beep/Beep/Beep
Enter into programming mode Bright -
- -
In the programming mode - -
Bright
Beep
Exit from the programming mode Bright -
-
Beep
Open the door - Bright
-
Beep
Alarm Bright -
-
Alarm
To enter the programming mode
* Master code #
999999 is the default factory master code
To exit from the programming mode *
Note: You must be in programming mode to perform any of the following functions
To change the master code
0 New code # New code #
The master code can be 6 to 8 digits long
Setting the working mode:
Set valid card only users
Set valid card and PIN users
Set valid card or PIN users
3 0 # Entry is by card only
3 1 # Entry is by card and PIN together
3 2 # Entry either by card or PIN (default)
11.1 User Settings
Page 4 of 8
Note: Only the installer data is restored, user
data will not be affected.
To Next Page
Loading...
Need help?
General