Need help?Do you have a question about the CAME BPT MTM and is the answer not in the manual?
Installation, programming, commissioning, and maintenance must be done by qualified technicians. Disconnect power during cleaning.
Keypad module connects on BUS. Assembly/removal requires no power. Includes sockets for additional modules.
Call keys are arranged for up to 98 keys, mapping keypad numbers to specific call sequences.
Steps to enter programming mode for VA/01 and MTMA/01-MTMV/01 systems via PROG LED.
Procedure to link call codes to internal receivers using specific key presses.
Assign codes to relays for door release or stairwell lighting. This action deletes previous codes.
Briefly press the PROG key to exit programming. Confirmation LEDs will turn off.
Steps to enter programming mode for MTMA/08 and MTMV/08 systems via PROG LED.
Procedure to link call codes to internal receivers using specific key presses.
Procedure to add access control codes for users via RFID PROG jumper and keypad entry.
Steps to delete specific access control codes for a group using keypad and RFID PROG jumper.
Procedure to remove all access control codes for a group via call code or call key.
Using the keypad for access control by entering valid codes to activate door release.
Making calls by entering the call code (1-98) followed by the key to initiate the call.
To Next Page
General
