CAME S.p.A.
Via Martiri Della Libertà, 15
31030 Dosson di Casier - Treviso - Italy
tel. (+39) 0422 4940 - fax. (+39) 0422 4941
RFID
+
Ð
M1
PROG
VA/01 - VA/08
Page 8 - Manual FB00877-EN - vers. 1 - 09/2017- © Came S.p.A. - The contents of the manual are to be considered as subject to change at any time and without the need for any advance warning.
This product complies with the relevant directives in force.
Decommissioning and disposal. Dispose of the packaging and the device at the end of its life cycle responsibly, in compliance with the laws in force in
the country where the product is used. The recyclable components are marked with a symbol and the material's ID marker.
THE DATA AND INFORMATION SHOWN IN THIS MANUAL ARE TO BE CONSIDERED AS SUBJECT TO CHANGE AT ANY TIME AND WITHOUT THE NEED FOR ANY ADVANCE
WARNING.
MEASUREMENTS, UNLESS OTHERWISE INDICATED, ARE IN MILLIMETRES.
Enter the call code (1÷98), followed
by key
: if the code is valid the
call will be made and the
LED will
come on .
Used to make calls
Press key , enter the access code
(3 to 8 digits long) and press key
again: if the code is valid a confirma-
tion beep will sound and the
LED
will come on, otherwise 3 fast beeps
will signal an error condition .
USE OF KEYPAD MODULE
Used as access control
When programming is completed, place the RFID PROG jumper as shown in figure
.
To Next Page
Loading...
Need help?
General
