CAME CBX series - Page 15

15
All the data and information contained herein is considered subject to change at any time and at our discretion
ENGLISH
5.7 Wiring gearmotors with mechanical end-stops to the command board
For the wiring, use appropriate sheaths and cable clamps to ensure the right degree of protection.
CONTROL PANEL
ZC3 / ZC3C
GEARMOTOR
C-BX
CONTROL PANEL
ZT6 / ZT6C
GEARMOTOR
C-BXT
&# &! &
#!-%
2
56 7%
76
5
&&#
&!
-
&# &! &
#!-%
2
56 7%
76
5
  #/-
-
&# &! &
4
4
CLOSE PUSHBUTTON
OPEN PUSHBUTTON
POWER SUPPLY
Condenser
Condenser
5.8 Direct connection by interlocking buttons only for C-BX gearmotor
#!-%
2
76
5
&&#
&!
-
Additional terminal not included
Note: connect the wires of the motor protection fuse in
a series with the wire connected to the “COM” terminal.