CAME CBX series - Installation

All the data and information contained herein is considered subject to change at any time and at our discretion
4
ENGLISH
5.1 Preliminary checks
Before proceeding with the installation, it is necessary to:
• The gearmotor must be installed in an area protected from shocks; the anchoring surface must be solid; and appropriate parts
(screws, plugs, etc) must be used to anchor the gearmotor to the surface;
• Provide for suitable omnipolar disconnection device with more than 3 mm between contacts to section power supply.
• Connections inside the case made for protection circuit continuity are allowed as long as they include additional insulation
with respect to other internal drive parts.
• Install suitable tubes and ducts for electric cable passage to guarantee protection against mechanical damage.
• The structure of the door must be sufficiently sturdy, the hinges must be efficient and there must be no friction between fixed
or mobile parts;
• Check the presence of a mechanical end-stop during opening and closing.
Installation must be carried out by expert qualified personnel and in full observance of regulations in force.
5 Installation
SECTIONAL DOORS SLIDING DOORS
FOLDING DOORS
4.4 Size measurements
Measurements in mm
4.3 Technical information
C-BX / C-BXE GEARMOTOR
Power supply panel: 230V A.C. 50/60Hz
Motor power supply: 230V A.C. 50/60Hz
Absorption*: 3A
Rated power*: 450W
Max. torque*: 60 Nm
Reduction ratio: 1/67.45
Drive shaft revolutions: 34(CBX)/20.5(CBXE)
Motor revolution speed: 21.5 rpm
Operative intermittence: 30%
Protection level: IP54
Weight: 15 kg
Working time:
#
#
C-BXE24 GEARMOTOR
Power supply panel: 230V A.C. 50/60Hz
Motor power supply: 24V D.C.
Absorption*: 9A max.
Rated power*: 240W
Max. torque*: 25 Nm
Reduction ratio: 1/67,45
Drive shaft revolutions: 20,5
Motor revolution speed: 26,5 rpm
Operative intermittence: intensive service
Protection level: IP54
Weight: 15 kg
Working time:
C-BXT / C-BXET GEARMOTOR
Power supply panel: 230-400V A.C. - 50/60Hz
Motor power supply: 230-400V A.C.-50/60Hz
Absorption*: 2,5A
Rated power*: 780W
Max. torque*: 80 Nm
Reduction ratio: 1/67,45
Drive shaft revolutions: 34(CBXT)/20,5(CBXET)
Motor revolution speed: 21,5 rpm
Operative intermittence: intensive service
Protection level: IP54
Weight: 15 kg
Working time:
#
#
#
#
* Values relating to the designated electrical board
#!-%
2



