CAME G3000 - Page 42

ESC < > ENTER
a3
ESC < > ENTER
i
ESC < > ENTER
cl i
ESC < > ENTER
op I
p.
18
18 - Manual code:
FA00028-EN
FA00028-EN v.
1
- 05/2015 - © Came S.p.A. The data and information in this manual may be changed at any time and without notice.
1. Select A 3.
Press ENTER to confirm.
2. Select 1 and press ENTER to confirm the travel calibration
operation.
3. The barrier will perform a closing maneuver until the limit-switch
point...
4. then, the barrier will perform an opening maneuver until the limit-
switch point.
Travel calibration


Before doing a travel calibration, establish the boom type, check that the boom is balanced and that the maneuvering area is free of
obstructions.
Important! During the calibration, all safety devices will be disabled except for the PARTIAL STOP.