Camon TC07 - Cleaning; Troubleshooting; Machine; Engine

To Next Page

To Previous Page

Tracmaster Ltd CAMON TC07 Turf Cutter

_______________________________________________________________________________________________

For parts diagrams visit www.tracmaster.co.uk

6.4 Cleaning

After cleaning, particularly if a pressure washer has been used, ensure any lubrication

points are re-lubricated.

Clean the engine with a cloth only. Avoid spraying the engine with jets of water as this may

leak into the fuel and ignition systems.

DO NOT PRESSURE WASH THE TRANSMISSION ASSEMBLY.

6.5 Troubleshooting

6.5.1 Machine

Have all serious malfunctions on the machine and engine repaired by an authorized

Tracmaster or Honda agent.

Problem Possible Cause Remedy

No drive to blade

Broken belt Replace belt

Damaged centrifugal clutch Replace clutch

Poor depth

Height lever not used

Lower the lever into

cutting position

Adjuster knobs incorrectly set

Adjust knob positions to

allow deeper cut

6.5.2 Engine

Problem Possible Cause Remedy

Engine does not start

Spark plug connector not

connected

Connect spark plug

connector

Choke lever is not actuated Actuate choke lever

Fuel tank empty Fill fuel tank

Fuel line clogged Clean fuel line

Defective spark plug

Clean or replace spark

plug

Engine has too much fuel

Dry and adjust spark

plug and start engine

Engine overheats Low engine oil Refill immediately

Impaired cooling Clean cooling fan grille

Air filter clogged Clean air filter