CAMPAGNOLO Ekar RD21 - Page 8

REPLACING THE JOCKEY CAGE - Rev. 01/ 06-2021 CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
8
6) Install the jockey cage fixing nut (Fig.7 /
Fig.7).
Tighten to a torque of 2.5 Nm (Fig.8).
5) Apply “Loctite 2701” (Fig. 6) to the jockey
cage fixing nut.
WARNING!
Observe the tightening torque.
A higher tightening torque could
damage the components inside the
rear derailleur, causing it to malfun-
ction.
7) Apply “Loctite medium 243” to the cover
(Fig.9).
8) Screw on the cover by hand (Fig.10).
9) Use an open-end spanner to tighten
the cover until a certain resistance is felt
(Fig.11).
WARNING!
Left-hand thread.
Fig.7 Fig.8
8
mm
Fig.6
Fig.9
Fig.10 Fig.11
8 mm
30 mm
2 Nm
2,5 Nm