Setup Like a Pro
Visit us at chpower.com
IN630400AV 6/09
1
4
3
1
Slide handle into
holes, Insert screws
and Tighten.
2
Thread one end of coil hose
onto fitting and the other end
onto blow gun. Use 2 adjustable
wrenches to Tighten both.
Using Compressor for Inflation —
Using Compressor with Air Tools —
Attach appropriate inflation
device to blow gun.
Turn ON compressor and
Squeeze trigger to inflate.
2
1
Attach air hose with
1/4 inch industrial plug
to coupler. *
Close regulator,
Turn ON compressor
and allow tank to Fill.
Attach air tool to
end of hose. Adjust
regulator for desired
application.
Use compressor for
desired application.
WL6700 Series - Rapid Inflation Air Compressor
Easy Setup Guide
NOTE: Coil hose and blow gun must be attached for compressor to operate properly.
Initial Setup —
• • • • • • • • • • • • • • • • • • • •
• • • • • • • • • •
• • • • • • • • • •
2
* Hose and Plug not included.
Apply thread tape to
both ends of coil hose.
Slide handle into shroud
holes, making sure handle
is on the outside of the
bracket and the holes of
the handle line up with
the holes of the
tank bracket.