Model 107 Temperature Probe
2
3. In the search box under the Available Sensors and Devices heading, type
in 107 or find the 107 in the Sensors | Temperature folder. Double-click
the 107 Temperature Probe. Data defaults to degree Celsius. This can be
changed by clicking the Deg C box and selecting Deg F, for degrees
Fahrenheit, or K for Kelvin. After entering the Properties, click on the
Wiring tab to see how the sensor is to be wired to the datalogger.
4. Select any other sensors you have, then finish the remaining Short Cut
steps to complete the program.
To Next Page
Loading...
Need help?
General
