9.3 Calibration
If needed, an estimate of the interchangeability error for 0 to 50°C, that can be used as the
Offset parameter of the Therm107() instruction, can be determined with a 1-point or 2-point
calibration. Calibration of the 107 probe is not necessary unless the accuracy needed in the
sensor data requires correction of the thermistor interchangeability offset described in
Specifications (p. 5).
10. Attributions and references
Santoprene® is a registered trademark of Exxon Mobile Corporation.
Measurement Specialties™ is a trademarked global designer and manufacturer of sensors and
sensor-based systems.
EPA installation standard: Quality Assurance Handbook for Air Pollution Measurement Systems –
Volume IV: Meteorological Measurements Version 2.0
WMO standard: WMO No. 8, Seventh edition, 6 Aug 2008 Guide to Meteorological Instruments
and Methods of Observation
107 Temperature Probe13
To Next Page
Loading...
