9. Once logged in, check the Status > Home > Network
State field. It should read Network Ready, indicating the
RV50(X) is connected to the cellular network. You can
easily test the RV50(X) connection to the Internet by
selecting the Admin > Advanced tab and using the PING
tool to ping an Internet server, such as
www.campbellsci.com.
10. Click the Template button in the ACEmanager toolbar.
A template application window will appear. Browse to
and upload one of the configuration templates
downloaded from Campbell Scientific.
Template Files
Template File
Name
Description
RV50_115200.xml
Default configuration with RS-232
at 115200 baud and Ethernet
communication enabled.
1
RV50_9600.xml
Default configuration with RS-232
at 9600 baud and Ethernet
communication enabled.
2
1
CR1000X series, CR300 series, CR6 series, CR1000, CR3000,
CR800 series, CR5000, and GRANITE 6/9/10
2
CR10X, CR10X-PB, CR510, CR510-PB, CR23X, CR23X-PB, and
CR200(X) series data loggers
11. Reboot the RV50(X) after successfully applying the
configuration template. You can do this by clicking the
Reboot button on the ACEmanager toolbar, by
momentarily pressing the Reset button (2 sec), or by
temporarily removing power from the RV50(X).
6. Enabling PPP mode
Launch the Device Configuration Utility . All tabs are within
the Deployment category.
On the Datalogger tab, change the data logger PakBus
Address and PakBus/TCP Password to match the values
entered in the Set up Konect PakBus Router (p. 2) step.
On the Com Ports Settings tab, select the COMPort where the
module is connected; this is generally RS-232. Change the
Baud Rate to 115200 Fixed.
On the PPP tab select the Config/Port Used where the modem
is connected. This is the same as was selected on the Com Ports
Settings tab. Set Modem Dial String to ATH;AT\APPP.
On the Network Services tab, in the PakBus/TCP Clients box,
type the DNS address and Port number noted during the Set
up Konect PakBus Router (p. 2) step.
Apply to save your changes.
Disconnect the Ethernet cable between the RV50(X) and
computer.
4
To Next Page
Loading...
