The cont ro l pane l can be clea ned by using a l ightly dam pened c loth .
Afte r cle aning, m ake sure t o dry it tho roughly.
For the ext e ri or, use a good a pp li ance po lis h wax .
Never u se s harp object s, sco uri ng pads o rhar sh c lea ners on a ny part o f the di shwasher.
Protect Again st Freezing
1.Cut off the electrical power to the dishwasher.
2.Tur n off th e wat er su ppl y an d d is connec t the wat er i nlet pipe from the w ate r val ve.
3.Drain the water from the inlet pipe and water valve. (Use a pan to catch the water)
4.Reconnect t he water inlet pipe t o the wate r val ve.
5.Remove the f ilter at the bott om o f the tub and use a spong e to soak up wate r in the sump.
pl ease take fros t protection m easures o nthe di shwasher in wi nter. Ev ery fter wa shing c ycles,
pl ease operat e as follow s
time a
:
- Inspec t t he filte rs fo r blo ckin gafter e ver y tim e th e di shwasher ha s be en u sed.
- By uns crew ing the coar se fi lter, y ou can remove the filter syst em . Remov ean yfoo d re mna nts and
cleanthe filters underrunning water.
Remarks:
Cleaning the Filter
Cleaning The Door
To c l ean t h e c o a rse fil t er and the fin e fi l t e r, use a cl eanin g bru sh . Reas se m ble the f ilt er par t s as sho wn i n th e f igur es
on th e las t pa ge and r eins ert t he e nti re ass em bly in the dis hwa sher, pos itio ning it i n i ts s eat and pres sing dow nwa rds.
The entire filter assembly should be cleaned once a week.
When cleaning the filters, don't knock on them. O therwise, the filters could b e
contorted andtheperformance ofthe dishwasher couldbe decreased.
To clean the e dge around t he door, you shoul d u se o nly a soft wa rm, d am p cl oth.
To avoid penetrat ion o f wa ter i nto the door l ock and elect rical componen ts, d o not
use a spr ay cleaner of any ki nd.
Never u se a spr ay c leaner t o cle an t he d oor panel as it m ay dam age the door loc k
and electrical components.
Abr asive ag ents o r som e paper towels shou ld not be u sed becau se o f th eris kof
scra t c hing o r l eav ing s pot s on t he stai n less st eel s ur fa ce.
Cleaning the SprayArms
I f your dis hwasher cannot w ork beca use of the ice,
pl ease contac t pr ofessiona l ser vice pe rso ns.
It is ne cess ar y t o cl e an th e sp ray a r ms regular l y for hard
water chemicalswill clog the sp rayarmjets and bearings.
To re move th e up per spra yarm, screw off the n ut cl ock wise then
remove thearm.
To re mov e th e l ow er spr ay arm , p ull out the spr ay a rm u pward .
Was h th e arm s in soa py a nd w arm wa ter a nd u se a sof t br ush t o
cleanthejets.Replace them afterrinsing them thoroughly.