The following things should be checked before starting the dishwasher.
The content of this manual is very he lpful to the users.
After installation, please make sure to keep this manua l.
1
The dishwasher is level and fixed properly
2
T he i nlet va lve is ope n
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
T he inl et an d dr ain hos es are k notte d
7
All packing materials and printings should be taken out from the dishwasher
Syphon Conn ection
Extension Hose
If you need a drainhose extension, make sure to usea similar drain hose.
It must be no lon ger th an 4 metres ; ot herw ise the c leaning effect of t he dishwasher coul d be reduced .
Wa t e r O ut l et
Connect t he wa te r dr ain h os e. The dr ain h ose must be corr ect ly fit te dto avoid wate r leaks.
Ensur e th at the w ater dra in hose i s no t kin ked or sq uas hed.
The waste connection must be at a height ofbetween 40cm (minimum) and 100 cm (maximum)
f ro m t he b ot tom o f t he dish . Th e w a t e r dr ai n h os e s hould be fixe d by a hose clip. T h e free en d of
the h ose mus t no t be imm ersed in water.
I f the s i nk is 1 000 h i gher from the floor, t he exc ess wa ter in h o se s ca nnot b e drai ne d direc tl y
into the sink. Itwill be necessary todrain excesswater from hoses into a bowl or suitable
containe r tha t is held out side and lower th anthe s ink.
How to Drain Excess Water From Hoses
To Next Page
Loading...
