Witheachwashcycle.
Compartment
For progr ammes with pre-wash on ly.
(Follow the user instr uctions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only .)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the d ishwasher has run.
Check the regeneratio n
salt level
Load the baskets
Close the door, t urn on the water tap and press the Start/reset button. The machine will start working
after about 10 seconds.
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent disp enser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will a lso dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher .
Scrape off any large amount of leftover food. S often remnants of burnt foo d in pans,
then l oad the baskets. Refer to the dishwashe r loading instructions.
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Open t he do or caref ul l y.
Hot st eam may escape
when the door isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select th e washing cy cle and operate th e dishwa sher
according to the original Power-on state ).
Switch on the applia nce Press the On/Off button to switch on the appliance, Open the door.
1.Open the doo r a little to stop the dishwasher.
2.After the spra y arms stop work ing, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwa sher will start running again after 10 seconds.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can only be modified if it has been running for a short time. O therwise the detergent
m ay have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Reset button for more than 3 second s to cancel the running programme .
3. Select a new programme.
4. Restart the dishwasher.
Select a programme
Turn the knob to select the desired programme
( S ee the s ecti on enti tle d Op erati o ng ins t ruct io n )“”
To Next Page
Loading...
