The dishes were not
loaded correctly.
See notes in " Loading the Dishwa sher Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearran ge the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dis hes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwashe r only once t
he dishe s are bare ly warm to the touch. Empty the low
bas ket fir st. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The p rogramme was
not powerful enough.
Not enough detergent
was dispensed.
Item s are blocking
the path of sp ay arms.r
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fit t ed.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed agai nst
dis hes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon
Wr ong program
has been selected
Use of cutlery with
a low-quality coa ting
If overflow occu rs, turn off the main water supply before ca lling a service.
If there is water i n the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher .
When some malfunctions c ome on, the applianc e w ill display error codes to warn you :
Longer inlet time.
Tap is not opened, or water intake is restricted,or water pressure
is too low .
Overflow.
Some element of dishwasher leaks .
To Next Page
Loading...
