The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the u sers.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
T he inl et va lv e i s o pen
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
T he i nlet and dr ain hoses a re knott ed
7
All packing materials and printings should be taken out from the dishwasher
Extension Hose
If you needa drainhoseextension, make sure to use a similar drain hose.
It must be no lon ger th an 4 met res ; ot herw ise t he c leaning effect of the di shw as her coul d be reduced.
Wa t e r O ut l et
Connect the wat er d rain hose. The dr ain h os e mu st be cor rect ly fit ted t o avoid wate r lea ks.
Ensur e t hat the w ater dra in h ose is no t kin ked or s q uas hed.
I f the s ink is 1000 h igh er f rom the f loor, t he exc ess wa te r in h o se s ca nno t b e dr ai ne d di r ec tly
into the sink. Itwill be necessary todrain excess water from hoses into a bowlor suitable
containe r th at is held out side and lower th an t he s ink.
How to Drain Excess Water From Hoses
Syphon Conn ection
Th e was te c onnection must be at a hei ght l e s s t han 100 0 mm (maxim u m) f rom t he bo t tom o f t he di s h.
The wat er dr ain h ose sho uld be fix ed .
To Next Page
Loading...
