Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indic ator on control pane l (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap . The mac hine will start working after about 10 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few m inutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload t he appliance, starting from the lower basket.
Changing the programm e
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then load the baskets. Refer to the dishwasher loading instruct ions.
Press the programme button until the selected programme lights up.
( See the section entitled Operation instruction )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, the n stop.
Turn off the appliance using the Power button.
If the appliance is switched
off during a wash cycle.
Op en the door car ef ul l y.
Hot st eam may esc ape
when the door isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select th e washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Open the door,Press the Power switch button to switch on the appliance.
1.Open the door slightly ,.
2.You can open the door completely until the spray arms stop .
3.Add the forgotten dishes.
4.Close the door, the dishwa sher w ill start running again after 10 seconds.
For detailed operating method read the co rresponding content on the instruction manual.
1. A running cycle can only be modified if it has been running for a short time. O therwise the detergent
m ay have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door slightly ,then press the program button more than 3 seconds to cancel the
running programme.
3. Select a new programme .
4. Close the door , restart the dishwasher .
To Next Page
Loading...
