Campomatic WM80LS - User Manual

Questions and Answers

S
Sabrina PotterJul 30, 2025
Why is my Campomatic Washer vibrating or making too much noise?
- N
  Nancy Webster DVMJul 30, 2025
  If your Campomatic Washer is vibrating excessively or is too noisy, several factors could be the cause. First, ensure the washing machine is placed on a level surface. Second, verify that the shipping bolts have been removed. Also, check to make sure the washing machine isn't touching any other objects. Finally, confirm that the laundry load is balanced inside the inner drum.
R
Robyn AbbottAug 4, 2025
What to do if my Campomatic Washer has an abnormal water supply?
- E
  Erika AlvarezAug 4, 2025
  If you're experiencing an abnormal water supply with your Campomatic Washer, start by checking if the water supply faucet is fully turned on. Next, clean the water supply valve filter. Finally, check the water pressure to ensure it's sufficient.
C
Christopher AdamsAug 8, 2025
How to fix abnormal draining in Campomatic WM80LS?
- L
  lisa52Aug 8, 2025
  If your Campomatic Washer is not draining properly, begin by cleaning the debris filter. Also, ensure the drain hose is correctly installed.
S
stephensaaronAug 12, 2025
What causes abnormal door lock on Campomatic WM80LS?
- T
  tstewartAug 12, 2025
  If you're experiencing an abnormal door lock with your Campomatic Washer, first check if the door is fully closed and firmly shut. Also, check whether the wiring harness of the computer board has fallen off.
J
Jamie AndersonAug 16, 2025
How to stop abnormal noise from drainage pump in Campomatic Washer?
- T
  Tiffany RoblesAug 16, 2025
  If the drainage pump in your Campomatic Washer is making abnormal noises, check if the drainage pump filter is blocked by laundry flocks. Clean the debris filter to eliminate the noise.
A
Aaron SimsAug 21, 2025
How to troubleshoot communication issues in Campomatic Washer?
- P
  Patrick WilsonAug 21, 2025
  If there's abnormal communication between the computer board and frequency conversion board in your Campomatic Washer, power off the machine and check if the wire connecting the motor and the electric reactor has fallen off. Also, check if the patch cord of the motor and cables have fallen off, and ensure the computer board wirings are securely in place.
T
Tammy HarrisAug 25, 2025
How do I fix temperature sensor abnormity in Campomatic WM80LS?
- D
  Dawn JohnsonAug 26, 2025
  If you suspect a temperature sensor abnormality in your Campomatic Washer, check if the NTC plug wire is making poor contact. You can also test the resistance of the temperature sensor in a cold state with a multimeter to see if it's above 1.5MΩ.