MAINTENANCE PROCEDURES
vmo2008-011-085_b
1. Screwdriver
2. Clutch adjustment wrench
To confirm proper adjustment, gen-
tly push on adjustment screw using a
screwdriver. A small axial p lay of ap-
proximately 0.5 m m (.02 in) should be
felt. If not, perform a djustment again.
vmo2010-012-003_a
1. Adjustment screw
A. 0.5 mm (.02 in)
NOTICE
A premature clutch disk
wear may occur if adjustment is too
tight.
Reinstall access plugs.
NOTICE
Do not overtighten.
vmo2010-012-001_a
1. Access plugs
2. Clutch cover
Properly adjust clutch le ve r. Refer to
ADJUSTMENT AT CLUTCH LEVER
above.
Throttle C able
Throttle Cable Lubrication
The throttle cable must be lubricated
with CABLE LUBRICANT (P/N 293 600
041) or an equivalent.
WARNING
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lub r ica nt) could
cause th e throttle lever/cab le t o
become sticky or stiff.
Remove the throttle lever housing
cover.
______________
103
To Next Page
Loading...
Need help?
General
