TROUBLESHOOTING AFTER INSTALLATION
If the appliance does not work properly after installation, perform the controls in the table.
The gas flow
seems irregular
Check that the gas cock is completely open.
Check that the fuel supply circuit has appropriate flow rate.
Check that the burner spreaders and relative caps are positioned correctly and free
from obstructions.
Check that the nozzles are suitable for the type of gas used.
Check compatibility and the correct calibration of the pressure regulator, if included.
Check the gas supply pipe (pipe obstructed, bent/crushed, excessively long,
unsuitable, etc.).
If the appliance still does not work properly after all the checks have been made, contact the
authorised local dealer.
To Next Page
Loading...